Accessories - YASKAWA FM 054 Manual

Basics and mounting
System conception > Accessories
Electronic module

2.2.3 Accessories

Shield bus carrier
Bus cover
Coding pins
12
The functionality of a SLIO periphery module is defined by the electronic module, which is
mounted to the terminal module by a sliding mechanism. With an error the defective
module may be exchanged for a functional module with standing installation. At the front
side there are LEDs for status indication. For simple wiring each module shows a corre-
sponding connection diagram at the front and at the side.
The shield bus carrier (order no.: 000-0AB00) serves to carry the shield bus (10mm x
3mm) to connect cable shields. Shield bus carriers, shield bus and shield fixings are not
in the scope of delivery. They are only available as accessories. The shield bus carrier is
mounted underneath the terminal of the terminal module. With a flat mounting rail for
adaptation to a flat mounting rail you may remove the spacer of the shield bus carrier.
With each head module, to protect the backplane bus connectors, there is a mounted bus
cover in the scope of delivery. You have to remove the bus cover of the head module
before mounting a System SLIO module. For the protection of the backplane bus con-
nector you always have to mount the bus cover at the last module of your system again.
The bus cover has the order no. 000-0AA00.
There is the possibility to fix the assignment of electronic and terminal module. Here
coding pins (order number 000-0AC00) from VIPA can be used. The coding pin consists
of a coding jack and a coding plug. By combining electronic and terminal module with
coding pin, the coding jack remains in the electronic module and the coding plug in the
terminal module. This ensures that after replacing the electronics module just another
electronic module can be plugged with the same encoding.
VIPA System SLIO
HB300 | FM | 054-1CB00 | en | 18-06