HOW TO USE THE REMOTE CONTROL
After unlocking, the red LED
flashes and the sensor can be
adjusted by remote control.
ADJUSTING ONE OR MORE PARAMETERS
CHECKING A VALUE
RESTORING TO FACTORY VALUES
SAVING AN ACCESS CODE
The access code is recommended for sensors installed close to each other.
DELETING AN ACCESS CODE
If you do not know the access code, cut and restore the power supply.
During 1 minute, you can access the sensor without introducing any access code.
If the red LED flashes quickly after unlocking, enter an
access code from 1 to 4 digits.
If you do not know the access code, cut and restore
the power supply. During 1 minute, you can access
the sensor without introducing any access code.
x
The number of flashes
indicates the value of
the chosen parameter.
3