Page 1
CRYSTAL INFRARED PRESENCE CURTAIN INSTRUCTION MANUAL FOR INDUSTRIAL APPLICATIONS We can be reached from anywhere in the world: US & Canada Toll Free 800-523-2462 (EST) US & Canada Toll Free 877-232-9378 (PST) Mexico Toll Free 001-800-711-1398 Latin America 412-782-5191 Email: sales@beainc.com B.E.A., Inc.
CRYSTAL INFRARED PRESENCE CURTAIN The Crystal active infrared presence curtain is ideal for threshold safety as well as an activation device when cross traffic is a concern. It is universally compatible with any door control and easily installed on new doors as well as on existing doors for retrofit purposes.
3. Install the cable (included in box). NOTE: If mounting directly to the header, pull the cable through the hole on the face of the header. Leave about 2 to 3 inches hanging out. Connect the JST connector to the Crystal. The plug connector is keyed and therefore can only be connected one way.
Dip switch #1 should be in the ON position for Crystal Presence detection. Dip switch #1 is also used to initiate a set-up of the Crystal. In order to initiate a set-up, dip switch #1 must be switched from ON to OFF and then to ON again.
DIP SWITCH #4 For maximum performance of the Crystal, dip switch #4 should be in the OFF position. If dip switch #4 is placed in the ON position, the sensitivity of the Crystal will be reduced. This should be done if a ghosting problem is experienced.
PLEASE NOTE The distance of detection from the door will increase as the mounting height of the Crystal is increased. It will also decrease as the mounting height of the Crystal is decreased.
WIRING SCHEMATIC THRESHOLD PROTECTION used with a motion detector: The Crystal must be wired in (NO & COM) in parallel with the motion detector. Door Control Activate (NO) Crystal Activation Device REVERSING DEVICE used with a motion detector: The Crystal must be wired in (NO & COM) in parallel with the photo eyes.