How To Use The Remote Control - BEA IS40 Installation Manual

HOW TO USE THE REMOTE CONTROL?

After unlocking, the red LED
flashes and the sensor can be
adjusted by remote control.
ADJUSTING ONE OR MORE PARAMETERS
CHECKING A VALUE
RESTORING TO FACTORY VALUES
SAVING AN ACCESS CODE
The access code is recommended for sensors installed close to each other.
DELETING AN ACCESS CODE
If you do not know the access code, cut and restore the power supply and, within the first minute, you can access
the sensor without introducing any access code. Additionally, within this minute an unknown access code may be
deleted via the remote following the steps outlined below. Press unlock, lock, 0, 0, 0, 0.
DELETING AN UNKNOWN ACCESS CODE
75.5695.07 IS40 IS40XL 20170313
If the red LED flashes quickly after unlocking, enter an
access code from 1 to 4 digits.
If you do not know the access code, cut and restore
the power supply and within the first minute, you
can access the sensor without introducing any access
code.
x
The number of flashes
indicates the value of the
chosen parameter.
Page 3 of 9