Assembly Of Camshaft; Assembly Of Connecting Rod/Crankshaft In Right Case; Connecting Rod/Crankshaft Set - PEUGEOT XP6 50 Manual

ASSEMBLY OF THE CAMSHAFT
This shaft is assembled tightly on the bearing.
Make sure you place it well with a plastic
hammer.
ASSEMBLY OF THE WHOLE JOINT/CRANKSHAFT
IN THE RIGHT CASE
CHECKING THE CRANKSHAFT
The side set of the head of the joint must be
between 0.14 and 0.41 mm.
Check the ligning-up of the crankshaft.
The values at the end must never be higher
than 0.04 mm.
ASSEMBLY
Place the crankshaft in its correct position in the
right semicase. Do this by hand.
Página 17 de 34