Replacement Of Bearings/Joints - PEUGEOT XP6 50 Manual

REPLACEMENT OF BEARINGS AND JOINTS
The opening of the housing cases of the engine
implies, at least, the replacement of the crank-
shaft bearings and joints.
Heat the housing cases at approx. 80ºC in an
even way (with a thermal layer remover, for
example) to expand them; the bearings will fall
off by themselves. Remove the joints.
Take advantage of the expansion to place the
new bearings in their position.
Lubricate the left tight joint and put it in its
position with tool, the edges towards the wheel
chamber.
IMPORTANT: Before heating the left case, we
recommend that you should remove the neutral
socket of the selector shaft.
NOTE: The right tight shaft will be installed
after closing the housing cases, placing the
torical and the separator, to avoid causing any
damage to its edges again when it touches that
same separator.
Replacement of the tight joints of the secondary
shaft:
Use tool to put this joint in the correct place and
position.
Replacement of the tight joints of the selector
shaft:
Use tool to put this joint in the correct place and
position.
Replacement of the clutch lever joints:
Use tool to put this joint in the correct place and
position.
Página 14 de 34