Place the clutch discs (4 upholstery discs, 3
plain discs), starting with an upholstery disc and
alternate upholstery discs and plain discs.
CAUTION: The plain discs have an assembly
mark:
During the assembly you must make sure that
the marks are 120º one from another.
NOTE: The new upholstery discs must be
(before the assembly) wet with the gearbox oil
(SAE 10W30 type SE).
Place the control lever of the clutch in its seat
equipped with its spring and washer after
lubricating it.
Introduce in the main shaft:
The push stick O5 length 116.6 mm (A).
The ball O4.8 (B).
The push rod of the clutch (C).
Assemble the pressure plate making the mark
(arrow) (2) meet with the mark of the clutch
rotor (round mark) (1).
Place the 4 springs, the 4 washers and make
sure you tighten the 4 screws properly with a
pair of 0.5 mdaN.
Página 25 de 34