Sinaut Configuration; D.3 Sinaut Configuration - Siemens SIMATIC S7-1200 CP 1243-8 IRC Operating Instructions Manual

STEP 7 V5 configuration of the proxy

D.3 SINAUT configuration

For dial-up network connections via TS modules, AT strings are configured in the "AT
Initialization" tab of the Properties dialog of the dial-up network node. Depending on the TS
module being used, the following AT strings are preassigned:
● CP with TS Module GSM
ATE0S0=1&D2+CBST=7,0,1;+CRC=1;&W+IPR=115200
● CP with TS Module Modem
AT&FE0&M0&Q6S0=1x3&w0
● CP with TS Module ISDN - partner (master station) with GSM connection:
AT string of the TS Module ISDN in the station:
AT&FE0\N1
Only when transferring via an ISDN network with the following configuration do the AT
strings need to be adapted manually in the "Initialization string" input box.
● CP with TS Module ISDN - partner (master station) with Modem MD4:
– AT string for the TS Module ISDN in the station:
– AT string for the Modem MD4 in the master station:
D.3

SINAUT configuration

Connection configuration with SINAUT Engineering Software
Configure the connection of a proxy in the SINAUT configuration tool in the same way as for
a TIM.
In the subscriber administration of the configuration tool, a proxy appears as follows:
Figure D-5 View of a proxy in the SINAUT subscriber administration
If you double-click on the selected subscriber (proxy) in the subscriber list, you will find the
corresponding entry for the expanded type in the properties dialog of the subscriber:
220
AT&FE0\N2
ATS45=85$P5\N0&W$M=1
Operating Instructions, 02/2018, C79000-G8976-C385-03
CP 1243-8 IRC