LEDs and connectors
2.2 LEDs
Display of the operating and communications statuses
The LEDs indicate the operating and communications status of the module according to the
following scheme:
Table 2- 5
Display of the operating and communications statuses
DIAG
LINK
(red / green)
(red / green)
Module startup (STOP → RUN) or error statuses
red
green
-
flashing red
-
green
-
red
-
flashing red
-
flashing red
-
flashing red
-
flashing red
Connection to Industrial Ethernet, status of the CPU
-
green
-
flashing green
-
-
flashing red
Connections via Ethernet
42
CONNECT
VPN
ETH
(green)
(green)
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
CONNECT
Meaning
RS232
(if more than one point listed: alternative
(green)
meaning)
Power OFF
Startup - phase 1
Startup - phase 2
-
Running (RUN) without serious error
-
Invalid STEP 7 project data
-
Missing STEP 7 project data
Backplane bus error with configured Ether-
net connections
Backplane bus error with configured connec-
tions via the serial interface
Backplane bus error with configured connec-
tions via the Ethernet and the serial interface
-
Connection to Industrial Ethernet exists
CPU in RUN.
-
Connection to Industrial Ethernet exists
CPU in STOP
-
No connection to Industrial Ethernet
-
Duplicate IP address detected in the Ether-
net network
Operating Instructions, 02/2018, C79000-G8976-C385-03
CP 1243-8 IRC