Assembly Instructions; Assembly Procedure - biodex NxSTEP 950-485 Instructions For Use And Assembly

2. Assembly Instructions

NOTE: The Assembly Instructions are detailed in the Unpacking and Assembly Prep segment of
the NxStep eLearning course.
Assembling the NxStep Unweighing System
The system should arrive at your facility fully
assembled. It is shipped in a compressed position
with the support bar tilted down and the cross
t u b e c ompressed. Initial use will require fully
expanding the cross tube and setting the support
bar to the fully raised position.
NOTE: If the system needs to be transported
through a doorway, hallway, etc., the cross tube
can be compressed and the support bar lowered
to make moving the system easier. Fully
compressed, the system will fit through a 36"
wide opening.
WARNING: At least two people are required
to complete the following procedure. Ensure that
the NxStep will be assembled on a level surface.
Ensure that there is enough room to easily move
around the NxStep frame during installation.

Assembly Procedure

The entire assembly procedure is covered in the NxStep eLearning Course. To watch the video
detailing the assembly process, please register for the course.
Figure 2.1. The Biodex NxStep in the
fully compressed
position.
11