Fit the wall units and extractor hood
before fitting the barbecue grill to
avoid damaging the surface.
~
The veneer or laminate coatings of
worktops (or adjacent kitchen units)
must be treated with 100 °C
heat-resistant adhesive which will not
dissolve or distort.
Any backmoulds must be of
heat-resistant material.
~
This equipment may only be used in
mobile installations such as ships,
caravans, aircraft etc. if a risk
assessment has been carried out by a
suitably qualified engineer.
~
After installing the grill, ensure that
the connection cable is without
hindrance and that there is no
mechanical obstruction which could
damage it, e.g. when draining the
appliance.
~
Ensure that the electrical cable is
installed in such a way that it does not
touch any parts of the appliance which
become hot. The cable will be
damaged by extreme heat.
Safety instructions for installation
~
Observe carefully the safety
distances given on the following pages.
~
Do not use any sealant except
where expressly instructed to do so.
The seal underneath the appliance
provides a sufficient seal for the
worktop.
All dimensions in this instruction booklet
are given in mm.
25