Safety Instructions For Installation - Miele CS 1421 Salamander Operating And Installation Instructions

Fit the wall units and extractor hood
before fitting the appliance to avoid
damaging the surface.
~
The veneer or laminate coatings of
worktops (or adjacent kitchen units)
must be treated with 100 °C
heat-resistant adhesive which will not
dissolve or distort.
Any backmoulds must be of
heat-resistant material.
~
This appliance may only be used in
mobile installations such as ships if a
risk assessment of the installation has
been carried out by a suitably qualified
engineer.
~
The salamander must not be
installed directly next to a barbecue
grill (CS 1312/1322) or a Tepan Yaki
(CS 1326). It is essential to maintain a
distance of at least 150 mm between
these two appliances.
~
After installation, ensure that the
connection cable is without hindrance
and that there is no mechanical
obstruction which could damage it.
~
Ensure that the electrical cable is
installed in such a way that it does not
touch any parts of the appliance which
become hot. The cable will be
damaged by extreme heat.

Safety instructions for installation

~
Observe carefully the safety
distances given on the following pages.
~
Do not use any sealant except
where expressly instructed to do so.
The seal underneath the appliance
provides a sufficient seal for the
worktop.
All dimensions in this instruction booklet
are given in mm.
19