Handicare SystemRoMedic RiseAtlas450M QuickTrolleySystem Manual page 5

Assembly of the trolley
Clearence hole for safety pin
To be able to mount and dismount the lift unit from the rail with the QuickTrolleySystem, the saftey pin, marked red in
fig 1, needs a clearence hole in the rail that enables the saftey pin to slide up and down. Mounting and dismounting the
lift unit from the rail will only be possible at the position where the clearence hole has been made.
I. Decide where on the rail the lift unit can be mounted and dismounted. NOTE! Distance, D in fig 2, from end of rail to
trolley depends on which end stop that is used, Table 1.
II. Drill a hole, diameter 10-12 mm, in the rail where the safety pin should slide up and down, fig 3.
III. Remove metal chips from the rail.
VI. Put the accompanying label on the rail to show the user where the lift unit can be mounted and dismounted, fig 4.
Fig 1; Safety pin
End stop used Distance, D
Stop bult 50 mm
Adjustable end 120 mm
stop
Table 1; End stop
UNLESS OTHERWISE SPECIFIED:
DIMENSIONS ARE IN MILLIMETERS
SURFACE FINISH:
TOLERANCES:
LINEAR:
ANGULAR:
Safety pin
NAME
Place the safety pin in the intended position in between the DRAWN
CHK'D
charger plates, fig 1. The length of the safety pin chosen
APPV'D
depends on the height of the rail, Table 2.
MFG
Q.A
SystemRoMedic
M A N U A L
TM
Fig 2; Trolley in position for mount-
ing / dismounting
Fig 4; Label on rail
FINISH:
SIGNATURE DATE
MATERIAL:
Material <not specified>
WEIGHT: 3643.85
UNLESS OTHERWISE SPECIFIED:
DIMENSIONS ARE IN MILLIMETERS
SURFACE FINISH:
TOLERANCES:
LINEAR:
ANGULAR:
SIGNATURE
NAME
DRAWN
CHK'D
APPV'D
MFG
Q.A
D
DEBUR AND
BREAK SHARP
EDGES
TITLE:
Trolley quick release
Height of rail
H64
Trolley_new_design_2
DWG NO.
H120 – H160
SCALE:1:10
FINISH: DEBUR AND
BREAK SHARP
Table 2; Length of safety pin
EDGES
DATE
MATERIAL:
Material <not specified>
WEIGHT: 3643.85
Fig 3; Trolley in rail
UNLESS OTHERWISE SPECIFIED:
DIMENSIONS ARE IN MILLIMETERS
SURFACE FINISH:
TOLERANCES:
LINEAR:
ANGULAR:
NAME
DRAWN
CHK'D
APPV'D
MFG
Q.A
DO NOT SCALE DRAWING
Safety pin
Short safety pin
M3x15 mm
Long safety pin
M3x25 mm
SHEET 1 OF 1
DO NOT SCALE DRAWING
TITLE:
Trolley quick release
Trolley_new_design_2
DWG NO.
SCALE:1:5
FINISH: DEBUR AND
DO NOT SCALE DRAWING REVISION
BREAK SHARP
EDGES
SIGNATURE DATE TITLE:
MATERIAL: Skena med vagn
DWG NO. A3
WEIGHT: SCALE:1:10 SHEET 1 OF 1
REVISION
A3
REVISION
A3
SHEET 1 OF 1
5