Introduction; Unit Nameplate; Compressor Nameplate; Gas Burner Nameplate - Daikin Maverick II MPS062E Installation And Maintenance Manual

This manual provides general informationabout the Daikin
Compressor Nameplate Maverick II rooftop unit, model MPS
062E - 075E. In addition to an overall description of the unit,
it includes mechanical and electrical installation procedures,
commissioning procedures, sequence of operation information,
and maintenance instructions. For further information on the
optional forced draft gas-fired furnace, refer to
The MicroTech III applied rooftop unit controller is provided. For
a detailed description of the MicroTech III components, input/
output configurations, field wiring and information on using and
programming the MicroTech III unit controller, refer to
For a description of operation and information on using
the keypad to view data and set parameters, refer to the
appropriate program-specific operation manual (see
Table 1: Program Specific Rooftop Unit Literature
Rooftop unit control configuration
Daikin Applied 208 - 460 V
Daikin Applied 575 V
VFDs
Daikin Applied 208 - 460 V
Daikin Applied 575 V

Unit Nameplate

The unit nameplate is located on the outside lower right
corner on the main control box door. It includes the unit
model number, serial number, unit part number, electrical
characteristics, and refrigerant charge.
Figure 1: Nomenclature
Daikin packaged system
Nominal capacity (tons)
Design vintage
www.DaikinApplied.com
IM 684 or IM 685.
OM 920.
Figure 1).
Operation manual number
OM 844
OM 895
OM 991
M P S – 062 – E L A
3

Compressor Nameplate

Size 62 units utilize the tandem compressor design. Each
compressor includes an individual nameplate along with a
nameplate identifying the tandem compressors.
Size 70-75 units utilize the trio compressor design. Each
compressor includes an individual nameplate. There is no
nameplate identifying the trio compressors.

Gas Burner Nameplate

On units that include gas heat, the nameplate is located on
the lower right corner on the main control box door. It includes
the burner model number,minimum/maximum input, maximum
temperature rise, and minimum CFM.

Hazard Identification Information

Cautions indicate potentially hazardous situations, which can result in
personal injury or equipment damage if not avoided.
Warnings indicate potentially hazardous situations, which can result in
property damage, severe personal injury, or death if not avoided.
Dangers indicate a hazardous situation which will result in death or serious
injury if not avoided.
Notices give important information concerning a process, procedure,
special handling or equipment attributes.
Heat medium
Y = None (cooling only)
A = Natural gas
E = Electric heat
W = Hot water
Cooling coil size
L =Large face area
S = Small face area
IM 991-2 • MAVERICK II ROOFTOP

Introduction

CAUTION
WARNING
DANGER
NOTICE
Introduction