Table of Contents
Advertisement
Installation – Optional Fluid Heaters
Fig. 8
WARNING
INJECTION HAZARD
To reduce the risk of serious injury,
follow the Pressure Relief Procedure
on page 19 before installing the heaters.
203A
Fig. 9
201a
201b
201
202
204
OUT
IN
203
10
02913A
204A
202A
RES
OUT
RES
IN
10A
All Models
NOTE: For systems requiring one heater for each
fluid, see page 40 to order the heaters and required
plumbing (items 201 to 205).
1. Mount a heater to each side of the mounting
bracket using the three screws (201a) and lock-
washers (201b) supplied with each heater. See
Fig. 8.
2. Connect a swivel union (202) to the outlet of each
heater. See Fig. 8.
3. Connect a swivel union (203) to the inlet of each
heater. See Fig. 8.
For Two Displacement Pump Models
1. Disconnect the existing hardener hose (10B) from
the inlet of the mixer manifold (23). See Fig. 8.
Connect the free end of the hose to the swivel
(203) at the hardener heater inlet. See Fig. 9.
2. Install a new fluid hose (204B) between the hard-
ener heater outlet (202B) and the hardener mixer
manifold. See Fig. 8 and 9.
3. Repeat Steps 1 and 2 for the resin pump (the
"A" side).
See Three Displacement Pump Models on next page.
23
204B
202B
HARD
OUT
HARD
10B
203B
IN
02893
308225
13
Advertisement
Table of Contents
