Spray Plate Assembly; Cloud Spray Plate Assembly - Mira MYLINE Installation & User Manual

Spray Plate Assembly

1. Use a suitable tool to remove the grommets.
2. Using the 2.5 mm hexagonal wrench
(supplied), remove the screws.
3. Separate the sprayplate assembly into its
individual components.
4. Clean or replace components as necessary.
Note! Make sure that the seals are located
correctly.
5. Reassemble the components in reverse order.
Replacing the Sprayplate or Seals
Grommet
Screws
Seals
Seals

Cloud Spray Plate Assembly

This product is supplied configured for the
majority of showering systems including electric
showers.
Note! for showers with a pressure of below 0.15
bar (1.5 metre head) it might be necessary to
change the Cloud sprayplate assembly for the
LC (Low Capacity) version in order to achieve a
suitable spray pattern.
Caution! The LC sprayplate must not be used
on electric showers
1. Use a suitable tool to remove the grommets.
2. Using the 2.5 mm hexagonal wrench
(supplied), remove the screws.
3. Separate the sprayplate assembly into its
individual components.
4. Replace the Cloud assembly sprayplate with
the LC version.
5. Reassemble the components in reverse order.
Screws
Low Capacity
Sprayplate
Replacing the Cloud Sprayplate Assembly
16
Grommet
Seals
Seals