Mira MYLINE Installation & User Manual page 12

7. Install the wall bracket and fully tighten the
fixing screw.
Note! The slot in the wall bracket allow for
minor adjustment.
8. Install the slidebar assembly into the
thermostatic mixing valve.
9. Position the slidebar support over the wall
bracket and secure with the securing screw
as indicated.
Wall Plug
Wall Bracket
Fixing Screw
Clamp
Bracket
Slide Bar
10. Pass it through the hose retaining ring and
install the showerhead onto the hose.
Note! Ensure that the sealing washers are
installed into the hose.
11. Place the showerhead onto the clamp
bracket.
12. Turn on the water and check for any leaks.
Securing Screw
Slidebar Support
Hose Retaining Ring
Hose
12
Showerhead
Sealing
Washer
Sealing
Washer