Kenwood NX-800 Service Manual page 16

NX-800
■ Install the KRK-10 main panel onto the transceiver
4. Insert the fl at cable that was removed in step 2 above
into the connector (CN1) of the interface unit (A/2) of the
KRK-10 main panel (A62-1101-11). ( u )
Note: The terminal side of the fl at cable must face down
when inserting the fl at cable into the connector.
5. Fit the main panel with four tabs onto the front of the
chassis. ( i )
Note: When installing the main panel onto the front of
the chassis, hold down the fl at cable with your fi ngers to
prevent it from being caught.
■ Install the KRK-10 rear panel onto the front panel
6. Insert the fl at cable attached to the interface unit (A/2) of
the KRK-10 rear panel (A82-0056-21) into the connector
(CN901) of the display unit of the panel ( o ). (The fl at
cable has been pre-inserted in the connector (CN2) of
the rear panel at the time of shipping.)
Note: The terminal side of the fl at cable must face down
when inserting the fl at cable into the connector.
7. Fit the four tabs of the rear panel into the front panel. ( !0 )
16
INSTALLATION /
■将 KRK-10 主控制盘安装到车载对讲机上
4. 将上述步骤 2 取下的带状电缆插入 K R K -10 主控制盘 ( A62-
1101-11) 接口单元 (A/2) 连接器 (CN1)。( ⑦ )
注意 : 将带状电缆插入连接器时，带状电缆的端子侧必须面
朝下。
5. 将带有四个凸起的主控制盘安放在底座的前面。( ⑧ )
注意 : 将主控制盘安装到底座的前面时，请用手指压住带状
电缆，以防带状电缆卡住。
Fig. 3-3 / 图 3-3
■将 KRK-10 后面板安装到车载对讲机前面板上
6. 将 KRK-10 后面板 (A82-0056-21) 接口单元 (A/2) 安装的
带状电缆插入面板显示单元的连接器 ( C N901) ( ⑨ )。( 出
厂时，后面板连接器中 (CN2) 已经预先插入带状电缆。)
注意 : 将带状电缆插入连接器时，带状电缆的端子侧必须面
朝下。
7. 将后面板的四个凸起安装到前面板。( ⑩ )
CN901
CN2
Fig. 3-4 / 图 3-4
安装
KRK-10 main panel
KRK-10主控制盘
CN1
KRK-10 rear panel
KRK-10后面板