Table of Contents
Advertisement
Discharge Cone Assembly-continued
Figure 38
For 36" and 50" discharge cone assembly refer to quicksheets included with hardware bags.
Wiring
(Diagram included with motor)
Be sure power is "OFF" before doing any wiring. All wiring shall be installed in accordance with national, state and
local electrical codes. Fans used to ventilate livestock buildings or other rooms where continuous air movement
is essential should be connected to individual electrical circuits. For electrical connection requirements, refer to
diagram on the motor nameplate. Motors are pre-wired for 230 volts unless otherwise specified. A circuit breaker
switch or slow blow motor type fuse must be used. Specifications are subject to change without notice. A safety
cutoff switch should be located adjacent to every fan.
©2017 Valco Companies, Inc.
ASSEMBLY COMPLETE
ELECTROCUTION!
Disconnect power
before servicing this
equipment.
27
ROTATING FAN BLADE!
Disconnect power before
servicing. Fan may start au-
tomatically. Do not operate
without guard
or screen in place.
Advertisement
Table of Contents
