Table of Contents
Advertisement
Regulations (Caution and Warning)
Do not install fan with moving parts within seven feet of floor or grade level with-
out a guard that complies with OSHA Regulations. Do not use unless electrical wir-
ing complies with all applicable codes. Do not wire without providing for power
source disconnect at the fan itself. Do not service except by a qualified maintenance
technician and only after disconnecting the power source. Do not install in room
where flammable material is stored or flammable vapors might build up. Failure to
observe all of these precautions can result in serious injury or death.
If these ventilation products are used to support life in agricultural structures where
failure of the system could result in loss or injury, the user must provide an ade-
quate backup and alarm system. The user must accept all risks of such loss or injury
due to the possible failure of the ventilation system.
Wiring Regulations
Be sure power is "OFF" before doing any wiring. All wiring shall be installed in accordance with national, state and
local electrical codes. Fans used to ventilate livestock buildings or rooms where continuous air movement is essen-
tial should be connected to individual electrical circuits. For electrical connection requirements, refer to diagram on
the motor nameplate or the enclosed wiring diagram. A circuit breaker switch or slow blow motor type fuse must be
used. Three phase motors do not include overload protection. Specifications are subject to change without notice.
(Diagram included with motor)
ELECTROCUTION!
Disconnect power
before servicing this
equipment.
8
ROTATING FAN BLADE!
Disconnect power before
servicing. Fan may start au-
tomatically. Do not operate
without guard
or screen in place.
©2021 Valco Industries, Inc.
Advertisement
Table of Contents
