Table of Contents
Advertisement
Auto Tensioner Assembly
11. Attach the 980068 Auto Tensioner Bracket at the same time the motor is being attached to the motor mount.
Attaching the Auto Tensioner Bracket at this point will eliminate having to unbolt the motor later. Use the (4)
010643 Hex Bolts and (4) 012789 Nylock Nuts (2 of each will be used to also attach the Auto Tensioner Bracket),
as shown below in Figure 12. Tighten (to approximately 140 – 150 in. lbs. ).
12. Attach the Auto Tensioner to the Auto Tensioner Bracket as shown in Figure 13. Leave the bolt finger
tight for now,
Figure 12
Figure 13
©2017 Valco Companies, Inc.
NOTE: Motor must be centered.
15
Advertisement
Table of Contents
