Table of Contents
Advertisement
Auto Tensioner Settings / Drive Belt Assembly
16. Loosen the 936026 Flanged Hex Head Bolt used to mount the tensioner to the bracket, then apply the Belt to
the drive (motor) pulley, around the tensioner pulley and onto the drive (fan) pulley.
Figure 16
17. Use a 15/16" wrench on the large Hex Head Nut on the front of the tensioner and a 9/16" wrench to tighten the
936026 Flanged Hex Head Bolt at the rear of the tensioner bracket. Rotate the tensioner clockwise and set the
tensioner between the 1st and 2nd markings shown in Figures 16 and 17.
Figure 17
©2017 Valco Companies, Inc.
ROTATE HEX NUT
to adjust tensioner
Turn Clockwise to
rotate tensioner
into place
17
Advertisement
Table of Contents
