Troubleshooting - G3D T-1000 Manual

TROUBLESHOOTING

Q1. Why does the print always peel away from the build plate during
printing?
Please try the following:
1. Make sure to calibrate the vat and position the build plate before printing.
2. Make sure to tighten the build plate lock screw, vat locking screws and
calibration levers.
3. Check and improve the support structures of your 3d model. For more
complexed designs, add supports.
4. Make sure to add base to your 3d model.
5. Adjust the cure time settings. Refer to the resin time settings of the
manufacturer.
Q2. Why is the print deformed or distorted after printing?
1. Make sure that the vat is clean and scratch-free.
2. Make sure that the projector is dust-free.
3. Make sure that your file and the projector is set to the correct XY resolution.
4. Adjust the focus of the projector.
5. Calibrate the vat and position the build plate.
6. Make sure that after printing you do not leave the print on the build plate
hanging for prolong period of time.
Q3. Why is the print misaligned after printing?
1. Make sure that the build plate is clean and without any evidence of
residue.
2. Make sure to tighten the vat lock screws and calibration levers.
T-1000 55