Safety - G3D T-1000 Manual

SAFETY

Please read the following safety precautions before operating the T-1000 UV
3D printer.
ELECTRICAL
• Do not modify or disassemble the printer.
• Modification to the printer voids warranty.
• Ensure to discharge static electricity when you configure the printer or
projector.
• Do not open front panel, rear panel and electronic panel while power is on.
OPERATION
• Keep printer in a well-ventilated area.
• Do not stare at the uv light for a long period of time during operation. It can
cause permanent loss of vision.
• Do not operate with wet hands.
• Shake the resin bottle well before each use.
• Uninterruptible power supply recommended.
GUIDELINES
• Do not expose printer to extremely high temperatures, such as direct
sunlight, flame or other sources of heat.
• Maintain the printer in a flat and sturdy surface.
• Keep printer dry.
• Do not remove the FEP sticker/film on the vat. It is for the vat's protection,
manufacturer's warranty will be void if it's damaged or removed.
T-1000 9