G3D T-1000 Manual page 47

ADJUSTING THE PROJECTOR
FOCUSING THE PROJECTOR
8. Configure the following settings.
Wear safety glasses for uv light protection for prolong exposure.
9. Press <
10. Ensure that the projected uv light of "G3D-TESTFILE-FOCUS" has identical
dimension with the calibration square. The projected UV light should be sharp.
If the uv light is blurred, adjust the focus ring of the projector.
44
Initial Layer Cure Time
No. of Initial Layer
#
Layers Cure Time
> button.
Position Build Plate
Cancel
SHARP
20
1
15
BLURRED
T-1000