Self-Leveling Vat - G3D T-1000 Manual

ABOUT 3D PRINTING

SELF-LEVELING VAT

The T-1000 has a self-leveling vat system which ensures accurate prints. After
several prints there's a possibility that the build plate can misalign after several
usage. An unlevel build plate can cause first layer issues that can result in poor
adhesion.
It is best to position the build plate before you print. This process will enable the
printer to self-level the vat and align the build plate.
Ensure to untighten all vat lock screws before you press < Position Build Plate>
button or this can damage the self-leveling system of the printer.
If the printer is newly purchased or you will use a new vat on the printer, untighten
all vat lock screws and release all calibration levers before you press < Position
Build Plate> button.
SELF-LEVELING VAT SYSTEM
FIG. 1 FIG. 2 FIG. 3 FIG. 4
After self-leveling, lock all calibration levers and tighten all vat lock screws to
prepare for printing.
6 T-1000