Eaton Cutler-Hammer VCP-WR Series Instructions For The Use, Operation And Maintenance page 3

IMPROPERLY INSTALLING OR MAINTAINING
THESE PRODUCTS CAN RESULT IN DEATH,
SERIOUS PERSONAL INJURY OR PROPERTY
DAMAGE.
READ AND UNDERSTAND THESE INSTRUCTIONS
BEFORE ATTEMPTING ANY UNPACKING,
ASSEMBLY, OPERATION OR MAINTENANCE OF
THE CIRCUIT BREAKERS.
INSTALLATION OR MAINTENANCE SHOULD BE
ATTEMPTED ONLY BY QUALIFIED PERSONNEL.
THIS INSTRUCTION BOOK SHOULD NOT BE
CONSIDERED ALL INCLUSIVE REGARDING
INSTALLATION OR MAINTENANCE PROCEDURES.
IF FURTHER INFORMATION IS REQUIRED, YOU
SHOULD CONSULT CUTLER-HAMMER.
A l l possible contingencies which may arise during installation, operation or maintenance, and all details and
variations of this equipment do not purport to be covered by these instructions. If further information is
desired by purchaser regarding his particular installation, operation or maintenance of particular equipment,
contact a Cutler-Hammer representative.
I.B. 8295A61H07
WARNING
Power Distribution Components Division
For more information visit:
THE CIRCUIT BREAKER ELEMENTS DESCRIBED IN
THIS BOOK ARE DESIGNED AND TESTED TO
OPERATE WITHIN THEIR NAMEPLATE RATINGS.
OPERATION OUTSIDE OF THESE RATINGS MAY
CAUSE THE EQUIPMENT TO FAIL, RESULTING IN
DEATH, BODILY INJURY AND PROPERTY DAMAGE.
ALL SAFETY CODES, SAFETY STANDARDS
AND/OR REGULATIONS AS THEY MAY BE APPLIED
TO THIS TYPE OF EQUIPMENT MUST BE STRICTLY
ADHERED TO.
THESE CIRCUIT BREAKER ELEMENTS ARE
DESIGNED TO BE INSTALLED PURSUANT TO
AMERICAN NATIONAL STANDARDS INSTITUTE
(ANSI) STANDARD C37.59. SERIOUS INJURY,
INCLUDING DEATH, CAN RESULT FROM FAILURE
TO FOLLOW THE PROCEDURES OUTLINED IN THIS
MANUAL. THESE CIRCUIT BREAKER ELEMENTS
ARE SOLD PURSUANT TO A NON-STANDARD
PURCHASING AGREEMENT WHICH LIMITS THE
LIABILITY OF THE MANUFACTURER.
Cutler-Hammer
Five Parkway Center
Pittsburgh, PA 15220
www.EatonElectrical.com
Instruction Book
Effective: February 2007
WARNING
Page iii