Compliance Notices; Compliance With Ce Regulations; Limitations On The Intended Operating Environment - TDSi EXcel4 User Manual

6 Compliance Notices

6.1 Compliance with CE regulations

The equipment is designed, tested and declared to conform to the following CE
directives:-
2014/30/EU
2014/35/EU
2011/65/EC
6.2 Limitations on the intended operating
environment.
The equipment is intended for use in access control applications in a wide range of
configurations. It is intended for use with third party equipment attached at the power
supply input, the reader inputs, various control outputs and the data communications
ports. Such third party equipment, and all cabling must be of suitable design and
installation to ensure that the overall system complies with the requirements of the EC
EMC directive.
The equipment in OEM Module form complies with the RFI emission and immunity, and
electrical transient immunity regulations. Compliance with the ESD regulations will be the
responsibility of any installer that mounts the OEM module in an alternative outer case.
Guidance notes for the installation and use of TDSi equipment must be strictly followed.
Due to the wide range of access control products TDSi notes cannot cover all possible
type and combinations of equipment that may be assembled to form a total system.
TDSi exercise due diligence to ensure that its equipment is suitable for use in the stated
applications, but ultimate responsibility for the compliance of a complete system must
rest with the prime contractor at a site where local conditions may require additional
EMC precautions to be taken.
EMC Directive
Low Voltage Directive
RoHS
EXcel4 Controller Page 46