Figure 15 - Com Port Select; Figure 16 - Xsearch Options - TDSi EXcel4 User Manual

Press the ESC key and then use the arrows up and down to highlight the COM port
required. For example COM 1, and then press "Enter" Key to select, which will default to
scanning all on the COM Port selected.

Figure 15 - COM port select

This then gives information of the Access Control Units on line.
If you have recently placed more than one unit on line then these will default to all being
unit 1, so you can press ESC to go back to the last screen, then press ESC again to get
the choices at the top of the screen again.

Figure 16 - XSearch options

These options allow you to select a specific UID range to scan.
"T" changes the options from Unit numbers to UID numbers.
"U" is to select the UID type e.g. EXCEL 4 press 4 and "Enter".
"B" allow you to select the Base or Starting UID number to search from i.e. Type the last 9
digits only e.g. 004-003-655. The search will start from this number.
"N" allow you to select the number to search on from the starting number selected with
"B".
EXcel4 Controller Page 26