Access Code; Troubleshooting - BEA EAGLE ONE HM User Manual

ACCESS CODE

The access code (1 to 4 digits) is recommended to set sensors installed close to each other.
SAVING AN ACCESS CODE:
DELETING AN ACCESS CODE:
Once you have saved an access code, you always need to enter this code to unlock the sensor.
If you forget the access code, cut and restore the power supply. During 1 minute, you can access the sensor without
introducing any access code.

TROUBLESHOOTING

The door remains
closed.
The LED is OFF.
The door does not
react as expected.
The door opens
and closes
constantly.
The door opens for
no apparent reason.
The LED
flashes quickly
after unlocking.
The sensor does
not respond to the
remote control.
BEA SA | LIEGE Science Park | ALLÉE DES NOISETIERS 5 - 4031 ANGLEUR [BELGIUM] | T +32 4 361 65 65 | F +32 4 361 28 58 | INFO@BEA.BE | WWW.BEA-SENSORS.COM
BEA hereby declares that the EAGLE ONE HM is in conformity with the basic requirements and the other
relevant provisions of the directives RED 2014/53/EU and RoHS 2 2011/65/EU.
The complete declaration of conformity is available on our website.
Only for EC countries: According to the European Guideline 2012/19/EU for Waste Electrical and Electronic Equipment (WEEE)
The sensor power is off.
The door control setting (F2)
is set to value 3 (closed).
Improper output
configuration on the sensor.
The sensor is disturbed
by the door motion or
vibrations caused by the
door motion.
It rains and the sensor
detects the motion of the
rain drops.
In highly reflective
environments, the sensor
detects objects outside of its
detection field.
In airlock vestibules,
the sensor detects the
movement of
the opposite door.
The sensor needs an access
code to unlock.
Batteries in the remote
control are weak or
installed improperly.
Remote control badly
pointed.
1 Check the wiring and the power supply.
1 Change the door control setting (F2) to value 1
(automatic).
1 Change the output configuration setting on
each sensor connected to the door operator.
1
Make sure the sensor is fixed properly.
2
Make sure the detection mode is unidirectional.
3
Increase the antenna angle.
4
Increase the immunity filter.
5
Reduce the field size.
1
Make sure the detection mode is unidirectional.
2
Increase the immunity filter.
3
Install the ORA (rain accessory).
1 Change the antenna angle.
2 Decrease the field size.
3
Increase the immunity filter.
1 Change the antenna angle.
2
Change the antenna.
3
Increase the immunity filter.
1 Enter the right access code.
If you forgot the code, cut and restore the power
2
supply to access the sensor without access code.
Change or delete the access code.
1
Check and change the batteries if necessary.
1 Point the remote control towards the sensor.