Settings For The Audio - Sony 3-299-549-11(1) Operating Instructions Manual

x [AUDIO (HDMI)]
You can select the audio output status from the
HDMI OUT jack.
[OFF]
[ON]
Note
• When you connect the control unit and TV with an
HDMI cable and [ON] is selected, [AUDIO DRC],
"A/V SYNC", TONE, "DEC. MODE", and sound
mode are not applied to the sound that is output from
the TV.
• When you set the function to other than "DVD", the
system does not output the sound from the HDMI
OUT jack even if you set [AUDIO (HDMI)] to [ON].
x [JPEG RESOLUTION]
You can select the resolution of JPEG image
files output from the HDMI OUT jack.
[SD ]
[HD ]
[HD]
[(1920×1080i)HD
[(1920×1080i)HD]
Note
• [JPEG RESOLUTION] is effective only when you
set [TV TYPE] in [VIDEO SETUP] to [16:9], and
you set [HDMI RESOLUTION] in [HDMI SETUP]
to other than [720×480/576p].
94
GB
The system does not output the
sound from the HDMI OUT jack.
The system outputs audio signals
by converting Dolby Digital,
DTS, or 96 kHz/24 bit PCM
signals to 48 kHz/16 bit PCM.
The system outputs standard
resolution with a black
frame.
The system outputs HD
resolution with a black
frame.
The system outputs the HD
resolution without a black
frame.
The system outputs full size
]
HD resolution with a black
frame.
The system outputs full size
HD resolution without a
black frame.
• You can select [(1920×1080i)HD
[(1920×1080i)HD] only when you set [HDMI
RESOLUTION] in [HDMI SETUP] to
[1920×1080i].
• If you select [(1920×1080i)HD
[(1920×1080i)HD], next image appears after black
screen.
• HDMI signal will stop momentarily when the system
is loading or unloading a DATA CD or DATA DVD
disc.

Settings for the Audio

[AUDIO SETUP]
AUDIO SETUP
S-AIR SETUP:
AUTO CALIBRATION:
DIGITAL IN: TV OPT, SAT/CABLE COAX
AUDIO DRC:
TRACK SELECTION:
x [S-AIR SETUP]
You can set up the S-AIR setting. For details,
see "Using an S-AIR Product" (page 74).
You can set the ID of the S-AIR
[ID]
main unit.
You can pair the system and
[PAIRING]
S-AIR sub unit, such as surround
amplifier or S-AIR receiver.
Note
• This function is available only when the S-AIR
transmitter is inserted into the S-AIR main unit.
x [AUTO CALIBRATION]
You can calibrate the appropriate settings
automatically. For details, see "Calibrating the
Appropriate Settings Automatically" (page 88).
] or
] or
OFF
OFF