Settings For The Audio - Sony DAV-DZ670M Operating Instructions Manual

Note
• This function is available only when [CONTROL
FOR HDMI] is set to [ON].
x [YC C /RGB (HDMI)]
B R
You can select the type of HDMI signal output
from HDMI OUT jack.
[YC C ]: The system outputs YC
B R
[RGB]: The system outputs RGB signals.
Note
• If the playback picture becomes distorted, set
[YC C ] to [RGB].
B R
• If the HDMI OUT jack is connected to a component
with a DVI jack, [RGB] signals will be automatically
output even when you select [YC
x [AUDIO (HDMI)]
You can select the audio output status from the
HDMI OUT jack.
[OFF]: The system does not output the sound
from the HDMI OUT jack.
[ON]: The system outputs audio signals by
converting Dolby Digital, DTS, or 96 kHz/24 bit
PCM signals to 48 kHz/16 bit PCM.
Note
• When you connect the unit and TV with an HDMI
cable and [ON] is selected, [AUDIO DRC], [A/V
SYNC], DYNAMIC BASS, "DEC. MODE," and
sound mode are not applied to the sound that is output
from the TV.
• When you set the function to other than "DVD," the
system does not output the sound from the HDMI
OUT jack even if you set [AUDIO (HDMI)] to [ON].
x [JPEG RESOLUTION]
You can select the resolution of JPEG image
files output from the HDMI OUT jack.
[SD ]: The system outputs standard
resolution with a black frame.
[HD ]: The system outputs HD resolution
with a black frame.
[HD]: The system outputs the HD resolution
without a black frame.
[(1920 1080i) HD
×
full size HD resolution with a black frame.
[(1920 1080i) HD]: The system outputs full
×
size HD resolution without a black frame.
C signals.
B R
C ].
B R
]: The system outputs
Note
• [JPEG RESOLUTION] is effective only when you
set [TV TYPE] in [VIDEO SETUP] to [16:9], and
you set [HDMI RESOLUTION] in [HDMI SETUP]
to other than [720 × 480p] or [720 × 576p].
• You can select [(1920 × 1080i) HD
1080i) HD] only when you set [HDMI
RESOLUTION] in [HDMI SETUP] to [1920 ×
1080i].
• If you select [(1920 × 1080i) HD
1080i) HD], the next image appears after the black
screen.
• HDMI signal will stop momentarily when:
– The system is loading or unloading a DATA CD or
DATA DVD disc.
– You connect or remove a USB device.

Settings for the audio

[AUDIO SETUP]
AUDIO SETUP
S-AIR SETUP:
SPEAKER FORMATION:
AUTO CALIBRATION:
AUDIO DRC:
TRACK SELECTION:
x [S-AIR SETUP]
You can set up the S-AIR setting. For details,
see "Using an S-AIR Product" (page 83).
[ID]
You can set the ID of the system.
[PAIRING]
You can pair the system and S-AIR sub unit,
such as surround amplifier or S-AIR receiver.
Note
• This function is available only when the S-AIR
transmitter (not supplied) is inserted into the unit.
x [SPEAKER FORMATION]
You can select the position of the speakers for
the better surround sound. For details, see
"Getting Optimal Surround Sound for a Room"
(page 89).
] or [(1920 ×
] or [(1920 ×
OFF
OFF
63
GB