Table of Contents
Advertisement
Step 4: Performing the
Quick Setup
Follow the steps below to make the basic
adjustments for using the system.
Note
• When you connect the system and the TV with the
component video cord (not supplied) or HDMI cable
(not supplied), you need to set the type of video
output for matching your TV. For details, see "Setting
the type of video output to match your TV" (page 36).
C/X/x/c,
1
Turn on the TV.
2
Press [/1 on the control unit and
POWER on the surround amplifier.
The system turns on.
Note
• Make sure that the function is set to "DVD"
(page 41).
3
Switch the input selector on your TV so
that the signal from the system
appears on the TV screen.
[Press [ENTER] to run QUICK SETUP.]
appears at the bottom of the TV screen. If
this message does not appear, recall the
Quick Setup display (page 36) and perform
again.
34
GB
4
Press
The Setup Display for selecting the
language used in the on-screen display
appears on the TV screen.
5
Press X/x to select a language.
"/1
The system displays the menu and subtitles
in the selected language.
6
Press
The Setup Display for selecting the aspect
ratio of the TV to be connected appears.
DISPLAY
7
Press X/x to select the setting that
matches your TV type.
x If you have a wide-screen TV or a 4:3
standard TV with a wide-screen mode
[16:9] (page 91)
x If you have a 4:3 standard TV
[4:3 LETTER BOX] or [4:3 PAN SCAN]
(page 91)
8
Press
9
Connect the calibration microphone to
the ECM-AC2 jack on the rear of the
control unit.
Set up the calibration microphone at the ear
level using a tripod, etc. (not supplied).
The front of each speaker should face the
calibration microphone, and there should be
no obstruction between the speakers and the
calibration microphone.
without inserting a disc.
LANGUAGE SETUP
OSD:
MENU:
FRANÇAIS
AUDIO:
SUBTITLE:
NEDERLANDS
.
VIDEO SETUP
TV TYPE:
PROGRESSIVE
(COMPONENT OUT)
4:3 OUTPUT:
4:3 LETTER BOX
PAUSE MODE:
4:3 PAN SCAN
.
ENGLISH
ENGLISH
DEUTSCH
ITALIANO
ESPAÑOL
DANSK
SVENSKA
16:9
:
16:9
Advertisement
Table of Contents
