[Audio Settings] - Sony BDV-N9200WL Operating Instructions Manual

x [SBM] (Super Bit Mapping)
[On]: Smooths the gradation of video
signals output from the HDMI (OUT)
jack.
[Off]: Select this when outputting
distorted video signals or unnatural
color.
x [IP Content NR Pro]
[Video3]/[Video2]/[Video1]/
[Film1]/[Film2]/[Film3]: Adjusts the
video quality for Internet content. This
setting is same as the setting in option
menu when using the Internet service.
[Off]: Off.
x [Pause Mode]
[Auto]: Normally select this. The picture,
including subjects that move
dynamically, is output with no jitter.
[Frame]: The picture, including subjects
that do not move dynamically, is output
in high resolution.

[Audio Settings]

x [BD Audio MIX Setting]
[On]: Outputs the audio obtained by
mixing the interactive audio and
secondary audio to the primary audio
during BDMV playback.
[Off]: Outputs the primary audio only.
58
GB
x [Audio DRC]
You can compress the dynamic range of
the sound track.
[Auto]: Performs playback at the
dynamic range specified by the disc
(BD-ROM only).
[On]: The system reproduces the sound
track with the kind of dynamic range
that the recording engineer intended.
[Off]: No compression of dynamic
range.
x [Attenuation settings - AUDIO]
Distortion may occur when you listen to
an equipment connected to the AUDIO
IN (L/R) jacks. You can prevent
distortion by attenuating the input level
on the main unit.
[On]: Attenuates the input level. The
output level will decrease at this setting.
[Off]: Normal input level.
x [Audio Output]
You can select the output method
where the audio signal is output.
[Speaker]: Outputs multi-channel sound
from the system's speakers only.
[Speaker + HDMI]: Outputs
multi-channel sound from the system's
speakers and 2-channel linear PCM
signals from the HDMI (OUT) jack.
[HDMI]: Outputs sound from the HDMI
(OUT) jack only. Sound format depends
on the connected equipment.
Note
• When [Control for HDMI] is set to [On]
(page 60), [Audio Output] is set to
[Speaker + HDMI] automatically and this
setting cannot be changed.
• Audio signals are not output from the
HDMI (OUT) jack when [Audio Output] is
set to [Speaker + HDMI] and [HDMI1 Audio
Input Mode] (page 61) is set to [TV].
(Europe models only)