Table of Contents
Advertisement
MAInTEnAncE, SErvIcE & InSTALLATIon SuGGESTIonS
MAInTEnAncE
The only maintenance that may be required is:
• Periodically clean the Exit Window of the GL3000P-E.
Do this with a soft cloth. Do not use Kleenex or paper
towels. Be careful not to scratch the glass.
Note: Always turn off power to the laser then cleaning
the Exit Window.
SErvIcE
No service is required and no service is to be performed
by the Customer. Only LaserLine Mfg., is authorized
to perform service. Any opening, tampering with, or
modifying the GL3000P-E Laser Housing by anyone
other than LaserLine Mfg., Inc. will void the warranty.
Warning! Under no circumstances, attempt to open or
disassemble Laser Housing. Doing so may cause expo-
sure to potentially hazardous levels of laser radiation.
FIG. 1 vEhicLE hEiGhT To LASEr SPoT on roAD chArT
10' (3.0m)
7' (2. 1 m)
5' (1.5m)
3' (0. 9 1m)
Maximum distance on road from laser to laser spot for optimum performance
InSTALLATIon SuGGESTIonS
1. Mount the GL3000P-E Laser on the vehicle at least 5 feet
off the ground. Most Operators prefer to mount the laser
on top of the cab. The higher up the laser is mounted, the
farther ahead of the vehicle you can aim the laser.
For best daylight visibility of the laser spot use the
distance versus height chart (Fig. 1) as the maximum
distance away from the laser the spot should be —
closer will be brighter, farther away will be dimmer.
2. The laser must be mounted to a stable surface. If
the laser base is vibrating (too flimsy a mount) on the
vehicle, the vibration is magnified at the laser spot and
can make it difficult to see. Stability of the laser mount
is very important.
3. Warning! Do not mount the laser inside the cab and
shoot the laser beam through the windshield without
the use of a boot. This is an unsafe practice as the laser
beam can reflect back off the windshield into the Opera-
tor's eyes (back scatter). Contact the factory for details.
4. Warning! Do not mount the GL3000P-E laser unit in a
location that allows the laser beam to be directed to
hit any shiny or reflective surface on the vehicle such as
chrome, side mounted rear view mirrors, or glass surfaces.
• Typically speaking, the closer to the vehicle the
more visible the laser spot.
10' (3.0m)
16' (4.87m)
4
23' (7m)
32' (9.75m)
Advertisement
Table of Contents
