Components & Controls - LaserLine GL3000P-E Owner's Manual

conTroL Box
1 Master Power Switch
on left side.
2 Move Left
3 Move Right
4 Move Up
5 Move Down
6 Laser Mode Switch
1st depression = on steady mode
2nd depression = blink mode
3rd depression = laser off
7 Key Switch
Disconnects power.
Requires key to operate laser.
8 Remote Interlock Interface Port (optional)
9 Shorting Bar - Remote Interlock Port
Remove if wiring the system
for remote laser shut off.
10 Power Cable to Vehicle 12 or 24 Vdc
• White wire
+ 12 or 24 Vdc
• Black wire battery ground
• Max current draw: 4 amps
• Internally fused (resetable type)
• Reverse voltage protected
11 Laser Control Cable
12 Emission Indicator
Redundant Dual Red LED
on Control Box and Laser.
GL3000P-E LASEr
13 Laser Exit Window
14 Mounting Holes (4)
Four holes provided to mount
laser to stable surface.
15 Mil Spec Connector
Connects control box to laser.
16 Purge Valve Set at Factory
Do not tamper with. Will void warranty.
17 Redundant Dual LED Emissions Indicator
Indicates emission mode of the laser
using dual LED redundancy.
coMPonEnTS & conTroLS
14
8
1
11
13
17
wArnInG!
Laser is filled with dry nitrogen to prevent moisture.
Do not open or tamper with purge valve, front, rear or
bottom covers. No user or non certified persons shall
access interior of laser! Removal of covers will violate
IEC Regulations and Factory Warranty.
3
4
6
Note:
9
3 amp
fuse
3
2
5
15
12
7
10
16