Download Print this page
Durafly Tomahawk Instruction Manual

Durafly Tomahawk Instruction Manual

Advertisement

Quick Links

Instruction Manual

Advertisement

loading
Need help?

Need help?

Do you have a question about the Tomahawk and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Durafly Tomahawk

  • Page 1 Instruction Manual...
  • Page 2: Required To Complete Model

    "FPV flying is the new way of looking at the world. The Durafly Tomahawk is the best way to get into mini racing FPV flying wings. This wing is only 670mm so it can be easily fitted in your car for an after work flight.
  • Page 3 ASSEMBLY : 1. Out of the box your Tomahawk comes with reinforced foam hinges. However before assembly can begin, each hinge line must be flexed back and forth 5-6 times to reduce tension and load on the servo.
  • Page 4: Setting Up Your Model

    3. Attach the bottom vertical find with CA foamsafe glue. NOTE: It is recommended that you balance the prop and spinner before installing for optimum performance and effciency. SETTING UP YOUR MODEL: 1. Before you install your propeller and with your receiver installed and all servos plugged into their corresponding channels, connect the flight battery to the ESC to power up the electronics.
  • Page 5 NOTE: For safety reasons, it is advised that this is done with the prop removed from the model. 2. Check all control surfaces are moving in the correct direction with the applicable stick input (see below) P.04...
  • Page 6: Control Throws

    3. The Tomahawk handles very well in flight and that’s not down to good design alone, but a good pre-flight set-up too. Before you fly you Tomahawk please follow the recommended settings below for optimum handling and performance. Control throws:...
  • Page 7 P.06...