Page 5
3.Horizontal Tail 4.Vertical tail 5.Main landing gear 6.Propeller/Spinner In its ‘Durafly Slow Poke’ 1200mm’ will still require some additional electronic companents to get it ‘flight ready’. Durafly recommends the products below for optimum performance and great value. hobbyking.com Available at...
Page 6
1. Out of the box your Slowpoke comes with reinforced foam hinges. However before assembly can begin, each hinge line must be flexed back and forth5-6 times to reduce tension and load on the servo. Do this for all control surfaces before continuing.
Page 7
3.With the aileron control horns at 90 degrees to the wing surface (neutral) insert the aileron push rod in the top hole of the control horn. (A). then Install the main wing. put the wing span to into the hole in the main wing. And glue the main wing . Slow Poke 4.As show put the main wing to the fuselage with 2xPM3x25mm and 2xPM3x50mm 2xPM3x35mm coarse thread screws .
Page 8
6. Install the propeller. Using spinner to lock the on motor shaft like the picture show. 7. Install the spring and Exhaust stacks. As picture show: Long wire: connecting Fuselage and the Main wing Short wire: connecting Horizontal tail and Vertical tail...
Page 9
Slowpoke The center gravity(CG) for the Slowpoke is approximately 85-88mm from the leading edge of the wing.
Page 12
As speed builds, ease off the amount of up elevator you have held in, then as soon as you rech 3/4 throttle you’ll start to see the Slowpoke lift of the ground. Landing the Slowpoke is a pleasure and a real treat for those who like to practice ‘scale’ type approaches as the Slowpoke will need to be ‘flown’...
Need help?
Do you have a question about the SlowPoke and is the answer not in the manual?
Questions and answers