Panic Alarm („S1"); D) Additional Functions - Renkforce GX111 Operating Instructions Manual

Gsm alarm device with gps tracking

Hide thumbs Also See for GX111:

Table of Contents

6. Panic Alarm („S1")

The button „S1" at the side of the housing can trigger a panic alarm. To trigger the panic alarm, push the button „S1"

for 3 seconds.

Activate panic alarm:

SET S1 #1513

Deactivate panic alarm:

RESET S1 #1513

The answer to this command can be delayed by up to 1 minute due to the GPS search. Immediate locali-

sation is more important, since this documents the location of the incident. The time of reaction to the alarm

text message, in contrast, is not known at all - therefore, GPS search takes precedence.

Alarm History („ALARMHISTORY")

The triggered alarm is logged in the device using a list. The list can save 2730 alarm entries. If the number of alarms

exceeds the threshold of 2730, the oldest entries are overwritten.

Since the alarm entry contains the date and time, alarm entries are only written into the list if the date in the

GX111 has been set (see chapter „GPSDATE"). The time is indicated in UTC.

If the following command was sent to the GX111, the two latest alarms are returned.

TEST ALARMHISTORY #1513

If more alarm entries are to be sent, you can add another parameter. This parameter is only considered when sending

command by text message, to avoid undesired costs.

TEST ALARMHISTORY <n> #1513

The parameter <n> specifies the number of Alarm entries to be sent out (1 to 10 of the latest alarms).

Up to 2 Alarm messages from the history per text message can be sent.

To delete the entire list of alarm entries in the GX111, use the following command:

RESET ALARMHISTORY #1513

Table of Contents