Table of Contents
Advertisement
„ACTION"
The „ACTION" commands permit the following:
SET
= switch on / activate / configure
RESET
= switch off / deactivate / factory settings
TEST
= test / check / request
ENABLE = activate the alarm system (only for the function „ALARM")
DISABLE = deactivate the alarm system (only for the function „ALARM")
Note on the „RESET" command:
If a function is to be switched off or reset due to an error, the corresponding „RESET" action must be used
with the corresponding function word! This action is universally applicable to all functions/text message
commands and resets the corresponding function to the default settings.
„FUNCTION"
This is used to select the function you want to change or perform:
TEL1
= phone book entry no. 1
NAME
= Name of the GX111
„PARAMETER"
Both the presence and the number of parameters depend on the function and action used. Therefore, most „RESET"
actions have no parameters while „SET" actions without parameters are rather rare (what should be set to which
value).
A parameter may be the following:
List:
You may choose a parameter from a pre-defined list.
e.g.: DE, EN
Writing: <DE/EN>
Number:
An integer without decimal digits.
e.g.: 60 = time [seconds] (SET IDLEALARM 60 #1513)
More information:
• Capitalisation is not relevant; you may use capital and small letters as you wish.
• Every new command of the same function will overwrite the previous settings.
• After every valid text message command, the GX111 will send a text message answer to confirm programming to
your mobile phone (if the PIN in the text message command was correct).
17
Advertisement
Table of Contents
