Commissioning - First Steps; A) Assembly And Charging Of The Product - Renkforce GX111 Operating Instructions Manual

8. Commissioning - First Steps

The following is needed for operation and configuration of the device:
• A conventional mobile phone that permits insertion of a micro SIM card for configuration of the GX111.
If your mobile phone is not equipped for use with a micro-SIM card, you will need the corresponding adap-
ter.
• An additional micro SIM card for the GX111
• A USB port (PC, notebook or included mains adapter) with USB cable
• A small Phillips screw driver for M2 screws to remove the covers of the GX111

a) Assembly and Charging of the Product

The product is delivered with the rechargeable battery inserted. However, it is not connected to prevent deep dischar-
ge.
Therefore, the housing of the GX111 must be opened and the PCB removed for first commissioning. Then the rechar-
geable battery can be connected and the GX111 assembled again.
Particularly observe the following items during assembly:
Rechargeable battery connection:
There is a connection for the rechargeable battery on the PCB side with the SIM holder right next to it. The plug is
pushed onto the holder from the top. The plug is protected against polarity reversal.
Rear cover (without opening for light sensor)
The cover is firmly screwed to the housing and covers the large opening with the PCB and the rechargeable battery.
The cover must be removed to replace the rechargeable battery. Then the PCB with the rechargeable battery can be
pulled from the housing.
When putting it together, observe that the seal on the cover inside is placed cleanly and has no damage.
The rubber washers also must be used for screwing to ensure best weather resistance.
Front cover
This cover covers all connections and status LEDs and has only a transparent opening for the light sensor. Only this
cover needs to be unscrewed for regular access to the product (USB, SIM, etc...).
The requirements to assembly of the front cover are the same as for the internal cover. However, observe that the
transparent opening should be checked for contamination so that the light sensor can work properly.
14