Error And Led Flashing Sequences; A) „Err" Led - Renkforce GX111 Operating Instructions Manual

14. ERROR and LED Flashing Sequences

a) „ERR" LED
The „ERR" LED displays different error messages and „Busy" signals. The messages are put out with a flashing code
for better differentiation. This sequence is repeated.
Additionally, there is the diagnosis mode in which the function of the „ERR" LED is assumed. For more
information, see chapter 10. c) on the command „DIAGNOSE".
„ERR" LED is not lit
• no error has occurred
• GX111 is not supplied with power or the rechargeable battery is flat
• Booting and self-test completed
„ERR" LED is always lit
• PIN-error
• PUK-must be entered
• a hardware error has been found during the self-test (connect the GX111 to a PC and check the USB-protocol)
„ERR" LED flashes slowly, LED on for 1 second, off for 1 second
• GX111 is booting
• Self-test underway
„ERR" LED flashes quickly 3 times, LED on for 0.25 seconds, off for 0.25 second
• Resetting to default settings is underway, flashing pattern is displayed before booting
„ERR" LED flashes slowly, LED on for 1.5 seconds, off for 0.5 seconds
• Error when loading the user settings
• Error when loading the default settings
„ERR" LED flashes quickly, LED on for 0.25 seconds, off for 0.25 seconds
• Data are being sent via email
42