E) Programming The Gps Zone („Gpszone") - Renkforce GX111 Operating Instructions Manual

Stopping recording:
To stop recording of the tracking data, send the command:
RESET TRACK #1513
The tracking data should be primarily downloaded via USB. Optionally, there is the operation of email dispatch as well.
Email dispatch requires higher technical knowledge. For more detailed information, see the chapters on the
commands „GPRS", „SMTP" and „TRACKDATA".
e) Programming the GPS Zone („GPSZONE")
The GX111 may be used for zone monitoring („GeoFence"). After programming the approved zone, each time the
zone border is crossed, an alarm message with the current GPS coordinates will be sent to all saved phone numbers.
If the zone monitoring is activated, the GX111 is always in „ONLINE" mode. This reduces battery life con-
siderably. Therefore, this function should only be used when supplied with power externally via USB.
The following command sets the zone parameters and activates them automatically:
SET GPSZONE <latitude1> <direction> <longitude1> <direction>
<latidude2> <direction> <longitude2> <direction> [<ZoneName>] #1513
Important prerequisites:
• <Latitude1> must be further North than <Latitude2>.
The following must apply: <Latitude1> larger than <Latitude2>.
The <direction> for the latitude is N (North) or S (South).
• <Longitude1> must be further West than <Longitude2>.
The following must apply: <Longitude1> smaller than <Longitude2>.
The <direction> for the longitude is E (East) or W (West).
• The <ZoneName> is optional (max. length 10 characters).
If the character length is exceeded, the GX111 returns an error message and the values are not saved.
Create a GPS zone with an edge length of 250 m around the actual GPS position:
SET GPSZONE #1513
Deactivation of the active zone; the zone parameters are retained:
SET GPSZONE DISABLE #1513
Activation of the deactivated zone:
SET GPSZONE ENABLE #1513
Deleting the zone:
RESET GPSZONE #1513
Reading the zone configuration:
TEST GPSZONE #1513
32