B) General Configuration Commands; Changing The Pin Code („Pin"); Changing The Device Name („Name") - Renkforce GX111 Operating Instructions Manual

b) General Configuration Commands

This sub-chapter describes all general configuration commands.
1. Changing the PIN Code („PIN")
To secure the GX111 from unauthorised access, the standard PIN „1513" may be set to any other value. The PIN code
can be changed as follows:
SET PIN <new PIN> #<old PIN>
Example: Changing old PIN 1513 to new PIN 1234:
SET PIN 1234 #1513
For every new text message command, the new PIN code now has to be appended (to stick with the example: 1234),
preceded by a crosshatch (#). If the wrong PIN code is entered or the PIN code is not sent, you will not receive an
answering text message. Changing of the PIN code will change both the settings of the product and the PIN code of
the micro SIM card! The PIN code always has 4 digits.
There is no „TEST" action for testing this function.
If you lose the PIN code, the GX111 can be reset to factory settings (see chapter „Factory Settings"). All
settings will be lost when resetting! Then the device must be set again.
Resetting the GX111 to factory settings will not affect the micro SIM card. The PIN code of the micro SIM
card is not changed.
2. Changing the Device Name („NAME")
If several GX111 are operated at the same time, it is recommended to assign a different name to each GX111. This
makes it easier to assign alarm messages to the correct device.
The device name has a maximum length of 20 characters.
To change the name at your GX111, send the following text message command:
SET NAME <new name> #1513
Example: Renaming to „NEWNAME":
SET NAME NEWNAME #1513
You will receive the following confirmation text message:
NEWNAME GX111 1.xx
To reset the device name to factory settings (no name), use the following command:
RESET NAME #1513
19