3.3 Connection of RTD Input Unit
Wiring Diagram and Internal Circuit Diagram
Terminal layout
(Note) Do not connect anything to N.C terminals.
•
For copper wires for wiring, use thick wires having insulation performance
of JISC3307 and JISC3401 or equivalents to prevent a large increase in the
electric resistance. It is recommended to ground the unit using the shielded
compensating lead wire.
•
Do not have the analog input wiring close to AC wires, power wires, or load
line from a device other than PLC. Also, do not bundle it with them.
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com