Barco OVERVIEW CDG67-DL Installation Manual page 68

The projector address and the common RC5 address is displayed.
The projector address is set to five, and the common RC5 address is zero. Therefore the projector will listen to
commands received from an IR Remote-Control unit with the address "5" and with the address "0".
To change a value:
•
Move the cursor key to the respective field.
•
Enter the new value by means of the numeric keys of the IR Remote-Control.
For an application it might be useful to have the Display Wall split into two parts, one
with the common RC5 address "0" and one with the common RC5 address "1".
6.6.1.1 Displaying a Projector Address by means of the Remote-Control Unit
Press the ADDRESS key (recessed key on the RCU) with a pencil. The projector's address will be displayed in a
'Text box'. This text box disappears after a few seconds.
To continue using the RCU with that specific address, it is necessary to enter the same address with the digit
buttons (address between 0 and 9) within 5 seconds after pushing the address key. For example if the Address
key displays projector address 005, then press "5" digit button on the RCU to set the RCU's address to match the
projector's address. Do not press 005 digits. This will address the remote control to '0' and control all projectors in
the room.
If the address is not entered within 5 seconds, the RCU returns to its default address (zero address) and control
all projectors in the room.
Barco – OverView cDG67-DL – R5976624– installation manual – Revision 03 – August-2005
6. Final Adjustment and Configuration
Service Menu, Projector Address
Projector Address and common address
________________________________________________________________
Figure 6-11
Figure 6-12
6-8