Barco OVERVIEW CDG67-DL Installation Manual page 65

This procedure optimizes the coupling of the active lamp into the optical system of the
projector and is immediately triggered by selecting the command Lamp Optimization.
During this procedure, the display gets dark for about 30seconds.
•
Use the cursor keys to highlight Lamp Optimization
•
Press ENTER to select.
If Operation|Message Box is enabled, the following message box is displayed:
The procedure should be performed subsequently for both lamps.
All other steps to configure the system have to be done in the service menu.
Barco – OverView cDG67-DL – R5976624– installation manual – Revision 03 – August-2005
6. Final Adjustment and Configuration
Lamps menu, Lamp optimization
Lamp optimization in progress
________________________________________________________________
Figure 6-6
Figure 6-7
6-5