Nortel 6220 User Manual page 57

4. Launch the Configurator by either double clicking the WLAN Cable
AP Configurator icon on your desktop or by opening the file
config.exe from the directory "C:\Program Files\Nortel\WLAN
Cable AP Configurator" where software is installed.
5. The Configurator runs the IP Address for your APU and the Test
CSU (and the IP addresses for any other devices in your network)
appears in the Configurator window, as shown below.
Figure 4-26
Configurator Starting Window
6. Ensure that the laptop computer gets an IP address assigned from the
DHCP server at Network Center or statically defined by checking an
IP address list box at the left side of the configurator window.
7. Check if all units of CSU(APU mode) and Test CSU have it's own
IP addresses.
8. If the CSU(APU mode) you wish to configure is on the same
network subnet as your computer, you can select it from the list that
is automatically displayed in the IP Address window. Press the <F5>
key to refresh the scan list. Alternately, you can also right click
anywhere in the scan window and select Re-scan the local network.
Note: To differentiate the CSU(APU mode) to be configured, you should
check the AP MAC address of the CSU(APU mode) which is printed on
the label attached to the side of the CSU(APU mode).
WLAN Cable Access Point 6220 CSU NTPM99CA Rel 2.0 Issue 5 Dec 2005
59