Table of Contents
Advertisement
4. Secure the cable in the EMI cap by tightening it with a cable tie. Cover
the connectors with black self amalgamating tape or shrink wrap tubing
to ensure a waterproof seal. This is the most crucial step in the
installation. If this procedure is disregarded or done insufficiently an
unexpected system fault could occur in a normal operation and affect on
the system performance factor relevant to the long term reliability.
5. Tighten the EMI cap securely with the special tool packaged in the
product box.
WHEN INSTALLING THE UNIT, CHOOSE A LOCATION THAT PROVIDES A
MINIMUM SEPARATION OF 20 cm FROM ALL PERSONS DURING NORMAL
OPERATION.
Figure 3-7
Covering the entry of EMI Cap and Shielded Cable with Tape or shrink wrap tubing
6. Connect the ground wire to the ground point at the lower right end of
CSU back panel.
Figure 3-8
Connecting the ground wire to the ground point
7. Connect the other end of the data cable to the POE Injector indoor.
8. Plug the power cord of the POE Injector into an electrical outlet
WLAN Cable Access Point 6220 CSU NTPM99CA Rel 2.0 Issue 1 Dec 2005
31
Advertisement
Table of Contents
