Nortel 6220 User Manual page 19

Table 1-2. Modules and Connectors (CSU)
Item Label
1 Antenna Radome
2 Enclosure(Body)
3 Logo Panel
4 DC Power Socket
5 Ethernet Port(POE) Provide data connection between CSU and POE Injector or LAN Switch
6 EMI Cap
7 Ground Point
8 Label(Front)
9 Label(Back)
10 Access Point
11 POE Splitter
12 POE Injector
13 Bracket Hole
14 Built-in Antenna(A) 5.8GHz Radio Frequency Antenna (Flat Panel) for 802.11a
Built-in Antenna(G) 2.4GHz Radio Frequency Antenna (Flat Panel) for 802.11b/g
THE 12V POWER CONNECTOR IS NOT INTENDED FOR FIELD USE. THIS
SOCKET IS ONLY APPLICABLE FOR A SPECIAL USE AT FACTORY OR
REPAIR FACILITY.
WLAN Cable Access Point 6220 CSU NTPM99CA Rel 2.0 Issue 1 Dec 2005
Protective Cover designed to contain a built-in antenna
Housing Integrated with an Antenna Case Assembly
Location for Nortel networks Logo
Provide DC power(12V) from AC-DC Adaptor to CSU
EMI Cap designed to prevent CSU from interfering to or from other devices
Additionally, provide water proof feature accompanied by sealing tape
Location for grounding the enclosure to earth for protecting the product from damage
Location for attaching a product label which include S/N,PEC,MAC address and so on
Location for attaching a product label which include S/N,PEC,MAC address and so on
Mini-PCI type III Radio Card, System Board(Secure Mode
Power Module to divide Ethernet Signal and DC power combined signal from POE Injector
Provide 802.3af based signal to CSU through Ethernet Port on CSU
Bolt Hole for assembly of mounting bracket
Description & Function
TM
)
19